FZM-1 Conventional Detector Connection Module
The FZM-1 conventional detector connection module is used to interface with and monitor 2-wire conventional detectors. The status (on, off, alarm) of a detector zone will be sent to the control panel for monitoring.
Detailed Information
- Powered directly from the SLC circuit without the need for an external power source.
- High immunity to interference (EMF/RFI).
- Direct address setting on the device with an address range of 01-159 using FlashScan protocol, and 01-99 using CLIP Mode protocol.
- LED flashes green during normal operation and turns red when a warning signal is received.
- UL and FM certified.
Technical Specifications
- Operating Voltage: 15 – 32 VDC
- External Power Supply: 24 VDC
- Maximum Current: 5.1 mA (LED on)
- Average Operating Current: 300 µA (LED blinking)
- End-of-line Resistance: 3.9 kΩ
- Operating Temperature: 0°C - 49°C
- Humidity: 10% - 93% RH
NCM-W Network Communication Card
The NCM-W communication card provides a connection to the Onyx 3030 central fire alarm control panel, the NCA secondary display, the ONYXWORKS graphics software, or between fire alarm control panels in a Noti-Fire-Net network.
ACM-24AT Auxiliary Display Unit
The ACS Series ONSX provides LED and switch modules to annunciate status and control fire alarm panels, network controllers, or specific system output circuits.
FMM-1 Monitoring Module
The FMM-1 module monitors dry-contact devices like flow switches and manual call points, transmitting their operational status back to the main fire alarm control panel.
24V FCM-1 Control Module
The FCM-1 addressable module provides 24V DC power for sirens and speakers, allowing activation manually or via the fire alarm control panel's programming software.
SSM24-6 Addressless Alarm
The SSM24-6 Non-Addressable Bell is a 6-inch sounder operating at 24VDC, with a loud output (~82dB), used for wired fire/burglar alarm systems, featuring polarized design, easy installation, and reliability.
FRM-1 Relay Control Module
The FRM-1 addressable module provides dry contact outputs to control peripheral devices, enabling activation either manually or via fire alarm control panel programming software.
ISO-X Isolation Module
The ISO-X isolation module is used in the Onyx fire alarm system to protect the system against short circuits on the SLC loop.
Addressable Emergency Push Button FSM500K/T(E)
This modern smoke detector meets UL268 standards, featuring dual LEDs for 360-degree visibility, rotary decimal addressing, and anti-interference technology to ensure maximum safety.
5601P Rate of Heat Detector
The 5601P heat detector is a key component in conventional fire alarm systems for industrial, apartment, and commercial buildings, offering high safety and cost-effectiveness, used where smoke detectors cannot be installed.
NBG-12LX Addressable Emergency Push Button
Addressable pull stations actively trigger early alarms during emergencies. They provide precise location data to the control panel, enabling responders to quickly reach the alert area.
System Sensor 885 Conventional Heat Detector
Features an LED indicator for alarm status (normally the light is off, but turns red when an alarm occurs). Includes a terminal for a room indicator light.
System Sensor 882 Conventional Smoke Detector
Features an LED indicator for alarm status (normally the light is off, but turns red when an alarm occurs). Includes a terminal for a room indicator light.
CHAU DUY PHAT COMPANY LIMITED
Email: sales@chauduyphat.com
Hotline: 028 35155101
Trụ sở: 204 No Trang Long, Ward 12, Binh Thanh District, HCMC
NEWSBOARD
Register as a member to receive news every day
@ Copyright belongs to Chau Duy Phat